Wallet took a minute for it to get here but I am glad for the patients. Does a look absolutely amazing?

these were perfect. I read reviews and they were 50/50 but none of the NEGATIVE reviews had a valid point. I ordered a set for a client. These were installed by and upholstery shop. Does not look difficult but we prefered to have them do it. We paid 500(3 shops quoted the same for labor in South Floirida) for total labor of removing seats, removing old covers, refoaming small areas, and installing center console(which was supplied) Overall, everyone was extremely happy with quality and fit. . I would definitely purchase again

Fit like a glove. Have purchased for two different Acura TL Type S

I was skeptical after reading some of the issues others have had on the C900 Facebook group. I was pleasantly surprised. I have a dark grey interior, and I initially ordered Silver Grey but was delivered Dim Grey. It was a mix up, but I got it sorted with LSeat and the Dim Grey was actually a much better match. The installation process is a bit of a pain, took me several hours, but it turned out great. I have two pieces of advice for installation: 1) Use extra long zip ties. Buy a big pack. Do not get the short ones or try to connect short ones to make a longer one. Trust me. 2) At least on a convertible, when doing the rear seat bench, drill one hole on either side of the mounting point and then snake a zip tie through there. Do not use the string method. This gives you a much tighter and better looking end result. I finished my seats with Leather Honey conditioner and 3M aerospace protectant, for UV. They turned out excellent and I'm very happy with this purchase. You'll notice a few wrinkles in the end result, but they've already smoothed out in the sun.

I was skeptical after reading some of the issues others have had on the C900 Facebook group. I was pleasantly surprised. I have a dark grey interior, and I initially ordered Silver Grey but was delivered Dim Grey. It was a mix up, but I got it sorted with LSeat and the Dim Grey was actually a much better match. The installation process is a bit of a pain, took me several hours, but it turned out great. I have two pieces of advice for installation: 1) Use extra long zip ties. Buy a big pack. Do not get the short ones or try to connect short ones to make a longer one. Trust me. 2) At least on a convertible, when doing the rear seat bench, drill one hole on either side of the mounting point and then snake a zip tie through there. Do not use the string method. This gives you a much tighter and better looking end result. I finished my seats with Leather Honey conditioner and 3M aerospace protectant, for UV. They turned out excellent and I'm very happy with this purchase.

Fit well, except for the head rests. They were off and I had to improvise. Color matching to the original interior was a shade off, but with samples provided, it is as close as I can get. If you are not handy person or have patience, pay someone to install them. :) Overall happy with the seats and result.

these folks are the only ones that carry replacement seat covers for Chevy S-10 trucks/Blazers and the quality was great! Would recommend for your replacement requirements.

The seat leather is not nearly as pliable as the original and could not be stretched tight enough to avoid all wrinkles. On the other hand my installer still did a good job and he said the better leather would have cost me about $1500-2000 more. I am not a perfectionist and my overall opinion is the general fit and feel is very good. It cost me $1,400 for the installation therefore the job came to about $1,850 versus a higher end cost of at least $3,000 to $3,500. Overall I am very pleased and with a little leather conditioning the seats look great.

After sending several pictures, and a written statement, the Logo was NOT in blue. It’s in ORANGE.

I installed new front and rear seat leather recently. I chose a medium gray as my factory light gray seats were worn and fragile and too light color for my eye. I recommend a sample before ordering to ensure color is what you want. L seat should improve the color selection process so it is fast and more accurate. Achieving a full and tailored result required adding additional foam layer to my seats. It was trial and error and required iteration to place foam and the pull seat upholstery tight to observe where foam was needed to fill out shape so leather fit with no wrinkles. The entire effort took me about 40 hours. My big tip is use zip ties for seat seam connections. Use the metal rings on seat perimeter. Buy the tool from lseat snd leather punch tool from amazon.

Easier than I expected to assemble, I did trim the fam back a bit and eliminated the head rest which worked out best for me as the seats are going into a custom application.

Feels great fits great and looks awesome. Thank you

Looks great Can’t wait until car is finished

Perfectly fitted. Almost as factory.

Our King Ranch was looking like three kids had grown up in it and we had never bothered to clean it or condition the seats. It was just easier to buy new seat covers and replace the carpet after they were out of the house. Seats look great. The magnet closure on the rear pocket leaves a little to be desired, but I am going to fix that. (Old seat covers in front, new in back)

Perfect fit and excellent quality

Perfect fit and great quality for 1975 Eldorao convertible front and back seats.

Thanks for making these custom seat covers for my Chevy Monza. They have an an unbeleiable fit. I would highly recommend using Lseat. com for your next project. A+ rating.

Good quality product . . . . . . . I had them professionally installed for $ 400. 00 excellent finished project, No disappointments

Stitch was good, fit was good, color a bit off but still close enough. Got it professionally upholstered. Made my car smell new again. Received in about 3 weeks. I can’t complain. Thanks